Package sewer pump stations have a lot of benefits. However, it is important to understand that for you to enjoy these benefits, you need to install the right pump station for your application. It is best to consult a professional to help you choose the right pump station for your needs. Once you choose the right pump station and install it correctly, you will enjoy the following benefits.
Supplied fully equipped
A packaged pump station is supplied complete with motors, pumps, valves, drive systems, level controls, inter-connection piping, motor control centre and level controls. The equipment can be installed into your existing building or can be supplied in a specialty enclosure.
The enclosures can include a standard fibreglass enclosure with several exterior appearance options, a standard fibreglass enclosure with a roll top, acoustic steel enclosures manufactured to size and concrete enclosures built to size.
Saves on civil engineering
This means that there is no need to install a separate valve chamber.
Saves on operating costs
The wet well is continuously and automatically cleaned because the pumps can pump to very low levels and remove all the contents with every cycle of the pump.
Good energy efficiency is also achieved by using motors that are highly efficient from your water solutions company. we will be able to keep your pump at its peak operating efficiency and servicing can be done by a single operator. It also has a very long service life compared to submersible pumps.
Saves on installation
Pump station is tested at the factory under the conditions of your site so that all that is needed is connecting power and piping. When upgrading your existing stations, upgrading the wet well size isn’t necessary because the suction lines should fit into the ell.
We upgrading your dry well installations, most of the infrastructure can be re-used when using a pump that is self-priming as pumps can be located at the level of the motor gallery or the ground level and re-use the wet well. Adding storage capacity by converting your dry well to a wet well is possible.
Improves safety
No matter how advanced and how good submersible pumps may be, there will always be a need for pump operators to open hatches for wet wells to access pumps, discharge bends and guide rails when they need replacement or repair. With the right self-priming pumps, operators don’t have to open wet well hatches.
The warranty
When you buy your package sewer pump stations from a reputable company, everything that comes with the package has a warranty. This means that if the equipment fails within the covered period, you will have a replacement.